[. . . ] When reinstalling or replacing parts, be sure to replace the Kapton tape correctly to retain the electrical protection and noise reduction the tape provides. file:///c|/docs/blanco E-doc/removing. htm (2 of 29) [9/1/2000 3:31:59 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series Customer-Accessible Components NOTICE: The steps in this section may be performed by customers. If the computer is connected to a port replicator, pull both release handles on the sides of the replicator to undock the computer. 3. The battery bay latch is located between the battery bay and the media bay. Pull the battery out of the bay. file:///c|/docs/blanco E-doc/removing. htm (3 of 29) [9/1/2000 3:31:59 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series NOTICE: Use the PC Card configuration utility on the taskbar to select and stop a card before removing it from the computer. [. . . ] You may find it helpful to print the following table to use for keeping the screws organized as you disassemble the computer. The table lists the components from right to left in the order that they are to be removed from the computer. Hard-Disk Drive 1 Hinge Covers 2 (piece across top of keyboard) Memory 2 Keyboard 2 (from top) Modem 2 Thermal Shield 4 (silver) for Inspiron 5000 5 (silver) for Inspiron 5000e (Remove the diskette-drive-cable retaining bracket before removing the thermal shield. ) Processor Module 3 for Inspiron 5000 2 for Inspiron 5000e Diskette Drive 2 (bottom of system) Palmrest 3 (from the top) 4 (bottom of media bay) 5 (bottom of battery bay) 3 (bottom of hard-disk drive bay) 5 (deep wells in base) Infrared Board No screws Speakers and Volume Board 9 (do not unscrew the speakers) (including both speakers and the volume board) LCD Hinges 4 (2 per hinge) Video Board 1 (silver) Support Rail 7 (back of computer) 4 (through top of support rail) (including the fan and the plastic strip) 15-Inch Display LCD Bezel 2 System Board 2 (serial port nuts) 2 (parallel port nuts) 2 (VGA port nuts) 2 (APR/PPR port nuts) 2 (screws into base) 15-Inch Display LCD Locking Tabs 4 (2 each) 15-Inch Display LCD Panel 8 (4 per side) 14. 1-Inch Display LCD Bezel 14. 1-Inch Display LCD Panel 4 6 (3 per side) 14. 1-Inch Display LCD Locking Tabs 4 (2 each) file:///c|/docs/blanco E-doc/removing. htm (7 of 29) [9/1/2000 3:31:59 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series LED/Inverter Board 2 ZIF Connectors NOTICE: ZIF connectors are fragile. Do not apply too much pressure to the movable part of the connector when opening or closing it. Some of the interface connectors are zero insertion force (ZIF) connectors. These connectors are not removable; they must be released to disconnect a cable from them. To disconnect a cable from a ZIF connector, perform the following steps: 1. Insert a small flat-blade screwdriver, dental pick, or fingernail under the movable part of the connector. Pull up gently on the movable part of the connector until the cable is released. To reconnect an interface cable to a ZIF connector, perform the following steps: 1. To ensure a firm connection, make sure the ZIF connector is completely closed. Modem Removal NOTICE: Only a certified service technician should perform repairs on your computer. When you replace the processor, be sure to attach it to the connector. file:///c|/docs/blanco E-doc/removing. htm (14 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series When you replace the processor during reassembly, be sure to attach it to the connector. LCD Removal NOTICE: Only a certified service technician should perform repairs on your computer. Damage or inoperability due to servicing not authorized by Dell is not covered by your warranty. NOTICE: Route the cable under the cable clip on computers that have extended cable clips so that the LCD flex cable will stay connected to the system board. Video Board Removal NOTICE: Only a certified service technician should perform repairs on your computer. Damage or inoperability due to servicing not authorized by Dell is not covered by your warranty. Disconnect the touch pad cable. file:///c|/docs/blanco E-doc/removing. htm (15 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series Diskette Drive Removal NOTICE: Only a certified service technician should perform repairs on your computer. Damage or inoperability due to servicing not authorized by Dell is not covered by your warranty. Detach the data cable. file:///c|/docs/blanco E-doc/removing. htm (16 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series 2. Remove the drive retaining screws from the bottom of the computer. 3. Remove the drive from the chassis. file:///c|/docs/blanco E-doc/removing. htm (17 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series Palmrest Removal NOTICE: Only a certified service technician should perform repairs on your computer. Damage or inoperability due to servicing not authorized by Dell is not covered by your warranty. Remove the three screws from the top of the computer. file:///c|/docs/blanco E-doc/removing. htm (18 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series 2. [. . . ] Remove the grounding tape that secures the wire harness to the back cover. Carefully snap out the flex cable pass-though housing from the back cover. Insert a flat instrument into the wide opening of the pass-through housing. Carefully ease the cover from the pass-through housing. 15-Inch UXGA, XGA, and SXGA+ Display Disassembly file:///c|/docs/blanco E-doc/removing. htm (27 of 29) [9/1/2000 3:32:00 PM] Removing and Replacing Parts: Dell Inspiron 5000 Series Bezel Removal 1. [. . . ]